Editing New Zealand

=PS1 Documentation=
An PS1 is an engineering document that's required for all Moddex Product for New Zealand. There are PS1's available to view on the NZ One Drive, or in some cases a specific PS1 is made for an project.

Should you require a PS1 for a project, it will be mentioned in the original handover

==Standard PS1 documentation==
<div class="toccolours mw-collapsible mw-collapsed">

===Assistrail===
<div class="toccolours mw-collapsible">
[[File:PS1-AR-1.png|frameless|1000px]]
[[File:PS1-AR-2.png|frameless|1000px]]
</div>

===Tuffrail===
<div class="toccolours mw-collapsible">
[[File:PS1-TR-1.png|frameless|1000px]]
[[File:PS1-TR-2.png|frameless|1000px]]
</div>

===Conectabal===
<div class="toccolours mw-collapsible">
[[File:PS1-CB-1.png|frameless|1000px]]
[[File:PS1-CB-2.png|frameless|1000px]]
[[File:PS1-CB-3.png|frameless|1000px]]
[[File:PS1-CB-4.png|frameless|1000px]]
</div>

===Bikesafe===
<div class="toccolours mw-collapsible">
[[File:PS1-BS-1.png|frameless|1000px]]
[[File:PS1-BS-2.png|frameless|1000px]]
[[File:PS1-BS-3.png|frameless|1000px]]
</div>

===Kliptread===
<div class="toccolours mw-collapsible">
[[File:PS1-KT-1.png|frameless|1000px]]
</div>
</div>

=MOE Type Work Design Intent/Shop Drawings SOP=
Please ensure the following points are reviewed & adhered to when reviewing MOE Type Shop drawings designs, anything not inline with these SOP’s please have Drafting team revise prior sending DI for client approval.
*4 hole baseplates by default unless told otherwise
*No Chemical Anchors-only use HDG 12mm screw bolt for concrete fixings
*75mm concrete edge distance will always be achievable onsite unless specifically stated meaning we can use Concrete screws unless reduced edge distance(50mm) is required
*Stainless Steel 180mm Coach screws in all timber areas with SS washer & Nylon separation washer
*All “handrails” and top rails to be 32nb
*Some situations where any standalone 1100mm high barriers are (Ie. Between canopy poles) could be 40nb top rail
*No closure bend/stop starts on parallel deck rails, always ensure end to end in one complete run wherever practical
*No handrails (AR150) to be attached to building cladding unless this is explicitly shown on plans/marked up drawings, AR10 (Stanchion mounted handrail) is the minimum requirement

=Green Rule=

For at least on end of the pipe, the sum of the tail and bend length (X+Y) must be at least 300mm, otherwise add 200mm green. Any tail (X) must be a minimum of 80mm, otherwise add 200mm green.

[[File:NZGREEN.png|200px]]