Moddex Bikesafe barriers ensure you protect cyclists, especially those travelling at speed, and eliminate or mitigate injury from falls. Bikesafe systems are quick and easy to install, with curved sections to flow with cycle ways.

The smooth continuous top rails help prevent or mitigate injury for both pedestrians and cyclists.

And your cycleway barriers can form part of a cohesive solution. Modular Bikesafe bikeway barriers are designed to integrate easily with our Conectabal and Assistrail range.

With six configurations available in the Bikesafe family, Moddex bikeway barriers offer:

Continuous full or partial offset barriers for protection across culverts, bridges, headwalls and hazards
Smooth and continuous top rails for injury prevention
Curves to flow with bike paths or cycle ways

Bikesafe Systems

BS10 - Bikeway barrier with offset top rail

BS20 - Bikeway barrier with offset top rail and midrail

BS25 - Bikeway barrier with offset top rail and handrail

BS30 - Bikeway barrier with offset top rail, midrail and bottom rail

BS35 - Bikeway barrier with offset top rail, handrail and bottom rail

BS40 - Bikeway barrier with offset top rail and balustrade infill

BS45 - Bikeway barrier with offset top rail, handrail and balustrade infill

Compliance

Moddex BS handrails are designed and manufactured in accordance with Australian Standard AS1657:2018 and relevant statutory WHS Codes of Practice/ Guidelines. Galvanized to AS 4792 and AS/NZS 4680:2006 (where applicable)

Common compliances

Moddex standard TR height is 1045mm however it can be designed between 900mm-1100mm in accordance with AS1657 (Preferred 1045mm)

Gaps between railing must be minimum 50mm

When creating TR as a barrier for headwalls, they don't need to be connected

Design tips

The distance from edge of closure to centre of stanchion is 324.15mm
To create a 50mm gap, insert TR 374.15mm away from wall/structure
When designing on stair sections, always set the correct heights with the tracing menu before connecting TR
Double check the TR pipe can go through the fittings (Double bends going through a top fitting may not work)

Technical data

Material
Stanchion & Rails	Clamp Fittings	Clamp locking screws
Steel/grade C250 & 350	Malleable Cast iron	Stainless Steel (304)

Protective Coating
Stanchion & Rails	Clamp Fittings	Optional
G390 Hot Dip Galvanized (min 390g/m2)	Hot-dip Galvanized with patented protective coating on threads	Powder coating and paint specs*

Dimensions

Stanchions & Rails
Diameter	Nominal Thickness
48.3mm OD	3.2mm

Clamp Fittings
Thickness	Locking Screws
5.0mm (approx)	M12 x 1.75 x 11mm - DEXX® Drive

Compliance

Common compliances

Design tips

Technical data

Dimensions

See also